The utmost care most be taken when taking the device apart.Īfter the vitals have been removed, it is time to move on to cleaning.This has been driving me crazy for the past few days. (Picture 4)ĬAUTION: Failure to take care of the board can cause the device to cease functioning. The Z button's contact sheet is attached with clips, but shouldn't be too hard to remove. Set aside buttons and contact sheets into two different piles for cleaning. (Picture 4)ĥ.) Remove the Contact Sheets and the Buttons from the Front Shell The control stick housing will be attached to the board at this point, so carefully set both the chip and the attached housing to the side. (Picture 3)Ĥ.) Remove the wire from the holders, and lift the Board carefully out The black screw holds the housing together, and will be dealt with in a later step. Make sure to only unscrew the three silver screws. Set the shell aside for cleaning (if needed, usually only the outside will need the cleaning.)ģ.) Unscrew the three silver screws that hold the Control Stick Housing in place To remove, push the Z button in, and slide up. The Z button is clipped into the back shell. Lift the shell carefully to avoid breaking any of the plastic screw holders. ![]() (Pictures 1 and 2)Ģ.) Remove the Back Shell and the Z button Make sure that all nine screws have been removed to safely remove the back shell. Seven of these nine screws are located on the back shell in plain sight, while two are next to the accessory input. WARNING: Make sure device is not plugged in, as there is a chance of injury due to electric shock.ġ.) Unscrew the nine screws that hold the Back Shell in place. The first step is to open the controller, and remove the components within: You can follow this guide if you do not know how to compile OpenEmu.Ĭlone this wiki locally N64 Controller Driver Open Source 2 Don't worry, it's an easy process! To compile OpenEmu, please ensure that you are using the latest stable version of Xcode. It is also possible to compile OpenEmu from its source files.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |